Basement laundry area


  #1  
Old 12-05-18, 12:07 PM
maarkr's Avatar
Member
Thread Starter
Join Date: Mar 2014
Location: United States
Posts: 479
Received 17 Votes on 15 Posts
Basement laundry area

I'm starting a project to insulate and frame my basement walls... 2" rigid foam board, 2x4 walls 16oc w m&m sheetrock. I'm starting with this 8' laundry area, since it's problematic. The pic shows the copper lines on the left going down the wall. I'd like to have an outlet box in the sheetrock for the washer connections.

How would you manage the existing water lines? I know the outlet box is fed from the bottom, so that's an issue, and the other is the fact that the lines are screwed to the wall, so I'd have to insulate around them if I left them intact. I could cut the lines up near the ceiling and maybe run PEX down and under the box when it's installed? or what else? appreciate ideas.

Name:  l1.jpg
Views: 186
Size:  28.3 KB
 

Last edited by PJmax; 05-23-19 at 03:46 PM. Reason: resized picture
  #2  
Old 12-05-18, 12:11 PM
M
Member
Join Date: Mar 2009
Location: Northern Virginia
Posts: 4,234
Received 22 Votes on 17 Posts
You could consider leaving that back wall unfinished and build a wall with bi-fold doors around the laundry area (front and right side).
 

Last edited by mossman; 12-05-18 at 12:26 PM.
  #3  
Old 12-08-18, 04:46 PM
D
Member
Join Date: Jan 2010
Location: Maryland
Posts: 439
Received 1 Vote on 1 Post
Not sure what the problem is. Cut the water lines and solder or use shark bite fittings to transition the water lines to pex or CPVC than into a wall box with valves for a washer. Run the drain line in the wall and into the washer box. Place a junction box with a blank cover on a 2x on the wall then run the washer plug to the location you need. The washer area is 8ft. Use 2x6 for that section of the wall to give you room to insulate and run your utilities.
Your walls are being built to hide the insulation and clean it up with sheet rock. Space your 2x4 s or 6 s at 24 oc to save on framing cost and time spent cutting foam board and 2x s.
If you can, the washer drain should be a 2" pipe.
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: