DoItYourself.com Community Forums > Exterior Improvement Center > Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete

Driveway slab edge crumbling

Thread Tools

Search this Thread

05-24-18, 02:02 PM

djoelt1

Member

Thread Starter

Join Date: Sep 2014

Posts: 31

Upvotes: 0

Received 0 Upvotes on 0 Posts

Driveway slab edge crumbling

My driveway was case in multiple sections of varying ages, and the edges at some points are crumbling. I would like to build these back up with polymer concrete or a similar product. What do you suggest for filling on the yawning gaps between the slabs? See photos for typical conditions.

Attached Images

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
What kind of damage is this to the concrete block?

D

David Geer on May 20, 2018

This concrete block is in the garage, right next to a man door, and is foundation for the garage wall I believe. What kind of damage or wear does this look like? How would you stop this "erosion" ? repair it and prevent further?Read More
Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
Concrete retaining wall repair

W

wyclef on May 26, 2018

[left]Hey, I've got an ancient load bearing wall that is doing it's job but is hideous with massive cracks and crumbling. It is so old and probably should be excavated and rebuilt but I cannot pay for that at this time and am interested in throwing some elbow grease and patchwork at it. I was thinking that i would rent a pressure washer because it was painted at one pount but its covered in moss algae dirt now however some spots are so bad it just looks like a bunch of rocks stuck together like a rice krispies treat. Wondering if there is some type of bonding thing i coukd paint on over what is there before proceeding or how to handle the prep here. Also, i'm on the fence about the process here. Was thinking throw some rapid set at the big holes and cracks then tack on some wire mesh or whatever you would use for some job like this, then scratch coat, then finish coat? Need some advice, not sure hiw pressure washing around small painted rocks will work.[/left]Read More

Ask a Question