How would you go about building this vanity? My contractor is putting in this new powder room but I'd like to build the vanity to save money and also have my only imprint in the project. Questions: How do I avoid an obvious seam on either the top or front? what type of wood would you recommend? Best way to hang it on the studs? I was planning to seal with Waterlox Original - sound ok? [url]https://www.houzz.com/photo/86608333-sunrise-point-farmhouse-powder-room[/url]

Hi I have a standard oven utility cabinet and am installing a single electric wall oven into it. The cabinet has ½” side and back walls, and a ¾” face frame. There is no solid bottom. The manufacturer of the oven says: “If the cabinet does not have a solid bottom, two braces or runners must be installed to support the weight of the oven. For single ovens, the runners and braces must support 200 lbs”. The diagram calls for “2" x 4" Runners Level with Bottom of Cutout and Flush with Sides of Cutout” Does anyone know how to do this? Is there any hardware that I can use? I was thinking of screwing in an L-Bracket into the face-frame and another to the back ½” plywood panel, and then attaching the 2x4’s on top of the braces. But will this be enough to support the weight? Thanks