Clean, recaulk bath surround
#1
01-30-19, 09:03 PM
Clean, recaulk bath surround
I've had some mold in a few areas around the bathtub for months.
I tried industrial cleaner, vinegar, baking soda, alcohol, pumice stone, Magic Eraser and
then finally Clorox Clean Up w bleach. The next day, there wasn't a trace of it.
Now I see some cracks in those areas. I was going to just put some caulk over them.
Then I see for some reason that's a no no - nobody ever says why! I did see a product that you can do
his...Permatex or something. Any experiences with this?
I tried industrial cleaner, vinegar, baking soda, alcohol, pumice stone, Magic Eraser and
then finally Clorox Clean Up w bleach. The next day, there wasn't a trace of it.
Now I see some cracks in those areas. I was going to just put some caulk over them.
Then I see for some reason that's a no no - nobody ever says why! I did see a product that you can do
his...Permatex or something. Any experiences with this?
Last edited by Chris12; 01-30-19 at 10:06 PM.
Sponsored Links
#4
01-31-19, 03:57 AM
As noted above it's best to cut/pull out the failing caulk and recaulk. You can buy a little time by just caulking the voids but putting a new bead of caulk over the old seldom fares well.
#6
01-31-19, 04:57 AM
Group Moderator
Yes, you need to remove the old caulk. New caulk will not stick well on top of the old and the old mold will be visible through the new caulk.
