Shower tray issue
#1
03-02-17, 12:04 PM
Join Date: Mar 2017
Posts: 1
Received 0 Votes
on
0 Posts
Shower tray issue
Our shower tray was never put in very well and causes mold to sit on the edges which caused the silicon to go mouldy. So my husband decided to get plastic trimming so that it would stop the water sitting on the tray edges.
What I'm wondering is once they are glued in what do we put in the large gap where the two parts of plastic join. It is quite a large gap. Can I just put silicon in there or do I need to do something else before putting silicon over the joint?
What I'm wondering is once they are glued in what do we put in the large gap where the two parts of plastic join. It is quite a large gap. Can I just put silicon in there or do I need to do something else before putting silicon over the joint?
Sponsored Links
#2
03-02-17, 12:36 PM
Welcome to the forums Emma!
Could you post a pic so we could better understand what you are dealing with?
http://www.doityourself.com/forum/el...-pictures.html
Could you post a pic so we could better understand what you are dealing with?
http://www.doityourself.com/forum/el...-pictures.html
