Inground pool light


  #1  
Old 04-26-17, 06:21 AM
J
JOB
JOB is offline
Member
Thread Starter
Join Date: May 2007
Location: new york
Posts: 44
Received 0 Upvotes on 0 Posts
Inground pool light

Hello having the liner in my inground pool replaced.The orginal 240 volt inpool light is being removed and a cover put over the light opening followed by the new liner.

The wiring for the light goes thru conduit that connects in a junction box outside the pool fence. The junction box is on a 2 x 4 .

Should I leave the wiring harness for the light and just disconnect it at the junction box, or pull it right out of the conduit and discard it ?

The only reason I can think of keeping it on the outside of the pool wall is for the possiblity of a light being re installed at a later date (much later, years later when the pool is getting it's next liner).

Any input would be appreciated.

Thank You
JOB
 
  #2  
Old 04-26-17, 08:55 AM
Marq1's Avatar
Member
Join Date: Sep 2016
Location: USA MI
Posts: 9,745
Received 1,210 Upvotes on 1,098 Posts
The trend now is LED lights so chances of ever using that wiring is slim to none!
 
  #3  
Old 04-27-17, 12:12 PM
I
Forum Topic Moderator
Join Date: Feb 2005
Location: Near Lansing, Michigan
Posts: 9,785
Upvotes: 0
Received 45 Upvotes on 43 Posts
I'd pull it back to the junction box on the post and cap off the disused wires with wirenuts. Also agree on the LED; nobody will ever be installing a 240V halogen light again.
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: