Earth wire connection into new board
#1
Member
Thread Starter
Join Date: Apr 2019
Location: Australia
Posts: 1
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Earth wire connection into new board
Hi All,
I have 3 separate Earth wires connected into an existing controller board. These 3 wires all have ring terminals and were hooked to a single brass earth bolt connector on the board. Now, As I'm replacing this board, i realised the new replacement board only has one Earth screw terminal.
What are my options rather than striping the 3 ring terminals and connecting all into this 1 terminal?
I have 3 separate Earth wires connected into an existing controller board. These 3 wires all have ring terminals and were hooked to a single brass earth bolt connector on the board. Now, As I'm replacing this board, i realised the new replacement board only has one Earth screw terminal.
What are my options rather than striping the 3 ring terminals and connecting all into this 1 terminal?
#2
Hi, why not just put the 3 ring terminals onto the new terminal? Post a pic of what you are trying to do.
Geo
Geo