I was running stringify to sync my lights to my ring motion sensors but the support ended. I've been trying ifttt and simple command but I can't set them to turn the lights off after a certain amount of time. The simple commands routine looks like it should work but doesn't run. I set doorbell motion as trigger. Light on. Light off with a 5 minute delay timer. When trying the test function it seems to work but when actually triggering the motion sensor nothing happened. When trying ifttt the lights come on by motion but I can't figure out how to add a step or way to turn them off eventually. Any ideas? Thanks

Quick background information, when most fish are in an Aquarium without an airpump, they will die soon when the water runs out of dissolved oxygen. I am looking for some kind of device that would monitor the power and if detected a loss of power to then activate an switch/circuit connected to the Airpump. Think of a standard UPS but for an Aquarium Airpump. The problem is I have a lot of Aquariums, very unreliable power and a vacation home in which I am away for long periods of time. ( Unable to plug in a battery powered pump) The standard USP design for computers can work for only shorts periods of time. Even though the airpumps don't use a ton of power, the inverter of the UPS seem to kill the battery faster then the air pumps connected to it. The APC UPS will make a loud buzzing sound and deplete the battery even if no devices are connected to it. As a result, the UPS will last a matter of a few hours if you are lucky ( not days) There is a product that is an battery connected Airpump connected to a extremely low quality and loud DC motor that contains the ability to power an airpump during a power outage. The device can monitor the power and the pump on when it detects loss of power however the air pump is extremely weak and can hardly produce any bubbles. I have found a new USB DC airpump on ebay which is powerful, produces a lot of bubbles, runs on DC power and only requires 1 watt of power. I have connected this to a small Lipo battery pack(solar generator). and was able to run for over 49 hours straight. This seem to be the best of all worlds except I need to figure out how to make it turn on during a poweroutage or even power by AC when power is on and switch over to a LIPO battery back when the power is off. Any idea on how such a thing could be accomplished. Does there exist basically a mini automatic transfer switch for a UPS that you can buy separately? Also, are you allowed to share links in this forum? I can send links to all the equipment I'm talking about if anyone is interested or wants to learn more about the devices I'm talking about. Thanks.