looking to buy a small chainsaw?/
#1
Member
Thread Starter
looking to buy a small chainsaw?/
I bought a poulan 2 years ago. But my arms are getting older and a small saw is in order. What do you reccomend.....disclaimer . I hold noone responsible! if i buy the wrong thing .....just me.So jump in and share with me. I want a 12" if i can little bigger if necessary thanks agai n for the help bob s
ps i have gift certificates for Craftsman saws i can use.

ps i have gift certificates for Craftsman saws i can use.
#2
It is going to depend on what you are cutting. Large trees call for a longer bar and a more powerful, yet heavier engine. Trimming limbs can be done with a lightweight 10" bar and light saw. Since you have Craftsman certificates, you'd be good to look at what they have to offer with your potential uses in mind.
#3
You didn't mention a budget, but pro brands (Stihl, Husqvarna, Echo, etc) has a small saw called an arborist saw. They are light weight and the handle is over the motor instead of behind it so it changes the balance. Pros use them when up in a tree for delimbing. You can even use them with one hand. (not recommended) Bad side: they are about $300
#5
To add. I have a rather large Poulan countervibe bow saw that I use once the tree is down, I use a 16" Poulan for felling the trees and a small Skil 10" my dad used to delimb the trees. So really it will boil down to budget, capabilities, physical limitations of the operator.
#6
Member
Join Date: Mar 2006
Location: Wet side of Washington state.
Posts: 16,321
Received 38 Upvotes
on
30 Posts
Where will you be using this saw? If you are within 100 feet of electrical power then an electric saw may be just the ticket. I have an old Remington "Limb & Trim" with a 14 or 16 inch bar and it has done everything I have ever asked of it, including cutting tree trunks over 20 inches in diameter.
Electric saws can be almost as fast as a gasoline saw and require minimal maintenance, no gasoline, no engine oil or mixed gasoline and are generally lighter in weight than a gasoline saw.
Electric saws can be almost as fast as a gasoline saw and require minimal maintenance, no gasoline, no engine oil or mixed gasoline and are generally lighter in weight than a gasoline saw.
#7
Has anyone had any experience with the pole trimming saws? Just curious, as it seems they would be a safe method to keep you from climbing a tree to trim a limb.
#8
Member
Join Date: Apr 2016
Location: USA
Posts: 27
Upvotes: 0
Received 0 Upvotes
on
0 Posts
I like the pole saws. Only used electric, so the motor is at the saw end. They get a bit difficult to manage the balance fully extended, but they work well, unless its a really tall tree
#9
Member
Pole Saw
I have an electric pole saw. The pole telescopes. The saw mounting bracket to the pole is offset to one side rather than being centered. This makes the saw difficult to handle when the pole is fully extended. The saw wants to rotate counter-clockwise.
My first chainsaw was a 14 in. gas Homelite. It was handy for limbing. Do not know if this model is available now.
My first chainsaw was a 14 in. gas Homelite. It was handy for limbing. Do not know if this model is available now.
#10
Member
Thread Starter
thank you again fellas for your help. Man! i gotta lota beers to buy -if i see you in the pub somewhere haha bob s really though. Thanks a million to you guys here on this great forum bob s
#11
Has anyone had any experience with the pole trimming saws?
I've got a 16' Stihl gas pole saw and it's great but heavy and when fully extended gets a little top heavy, definitly not a light weight unit the OP is looking for.
I used to have a small electric chain saw when I lived in the great wilds of suburban CA (1/5 acre lot) believe it was a 12" black and decker and it was very light weight weight and cut pretty good.
#12
Member
I never did see a reply to the question what are you using it for, yes I know you trying to cut wood, but there's far more to it then that.
Cutting just a once a year limb that falls in the yard, clearing a lot off, cutting cords of firewood?
As mentioned a 12" or longer bar requires a bigger heavy saw.
Not enough CC's and the saw will be stalling out in the middle of the log.
Cutting just a once a year limb that falls in the yard, clearing a lot off, cutting cords of firewood?
As mentioned a 12" or longer bar requires a bigger heavy saw.
Not enough CC's and the saw will be stalling out in the middle of the log.