I have a 6 panel pine door that was coated with Minwax Maple Polyshades. Doesn't match other woodwork / trim / doors which were all properly conditioned, stained, and coated with satin poly. I want to remove the Polyshades and do it like the rest was done. My question is about removing the Polyshades. I could sand the flat surfaces OK, but the detail trim around the 6 panels would be a problem. How about chemical stripper? I could work outside so odors aren't a problem. Any recommendations on a good stripper? Or other ideas? Product / how to use / how much needed for 1 door (both sides)/ cautions are all appreciated! Thanks, Steve

I am having a bathroom renovated and you can see a different texture on the wall vs. the area that was spackled. The paint on the spackle is smooth whereas the paint on the wall is textured as expected from the roller. The painter told my PM that this is normal and cannot be fixed without a skim coat. That doesn't make sense to me. The spackle takes primer/additional coats but should ultimately have the same texture. Correct? I've attached a few pics for reference. It's a bit hard to see but it does show the difference.