Is this how I wire fuel pump sender connector?

Reply

  #1  
Old 08-20-19, 09:58 PM
B
Member
Thread Starter
Join Date: Jul 2007
Location: Arizona
Posts: 1,285
Received 3 Votes on 3 Posts
Is this how I wire fuel pump sender connector?

Same old 92' Ford Ranger XLT with 2.9 V6. I got the new in-tank fuel pump installed from related posting. But when I disconnected the old fuel pump sender connector, I found it to be in bad shape and falling apart. I have a new connector ready to install this coming Saturday, It came with crimp terminals and heat shrink tubes.

The new connector has four black wires. The wiring bundle from the truck has colored wires
(attached photos). I think I know how to connect the wires.

I orient the new connector exactly like old one, with locking tab facing down.

Then
OUTER LEFT BLACK WIRE is crimped to ORANGE WIRE
INNER LEFT BLACK WIRE is crimped to YELLOW WIRE
INNER RIGHT BLACK WIRE is crimped to RED WIRE
OUTER RIGHT BLACK WIRE is crimped to BLACK WIRE

....................correct?

Name:  p1.jpg
Views: 72
Size:  94.9 KB

Name:  p2.jpg
Views: 79
Size:  48.6 KB
 

Last edited by PJmax; 11-11-19 at 05:31 PM. Reason: resized/labeled picture
  #2  
Old 11-11-19, 01:52 PM
B
Member
Thread Starter
Join Date: Jul 2007
Location: Arizona
Posts: 1,285
Received 3 Votes on 3 Posts
All done! Figured it out. No problems.
 
  #3  
Old 11-11-19, 05:32 PM
PJmax's Avatar
Group Moderator
Join Date: Oct 2012
Location: Northern NJ - USA
Posts: 60,786
Received 1,326 Votes on 1,225 Posts
I hadn't seen that you replied to your own post until after I resized the pictures.
 
  #4  
Old 11-11-19, 08:40 PM
B
Member
Thread Starter
Join Date: Jul 2007
Location: Arizona
Posts: 1,285
Received 3 Votes on 3 Posts
I see you color coded it also. Thanks Pete!
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description: