Replacing a section of copper pipe

Reply

  #1  
Old 01-22-17, 08:13 PM
D
Member
Thread Starter
Join Date: Jan 2017
Location: USA
Posts: 41
Received 0 Votes on 0 Posts
Replacing a section of copper pipe

hi there,

any tips for for replacing/repairing a section of copper pipe with couplers.

so i have to replace a section of 3/4" copper pipe. i know how to solder and so i was going to use two 3/4" copper couplers on each end.

let me know if i'm doing something wrong.

i cut out a 4 inch section. each coupler has a 7/8" depth to it. so is the trick to solder together a section of copper pipe and coupler on each end to total something like 4.5 inches and just accept that the ends of the repair section will only have about 1/4 inch depth into the coupler? otherwise i can't imagine squeezing/bending copper pipe to fit a repair section of 5.75 into a gap of 4 inches.

i can't think of a way to get 7/8" depth on each coupler when the plumbing is in line.

thanks!
 
Sponsored Links
  #2  
Old 01-22-17, 08:47 PM
PJmax's Avatar
Group Moderator
Join Date: Oct 2012
Location: Northern NJ - USA
Posts: 59,742
Received 1,187 Votes on 1,098 Posts
When replacing a piece of inline copper pipe..... you use no-stop couplers. The no-stop coupler slides completely over the pipe to allow the pipes to touch. All ends must be carefully cleaned and filed so that the couplers slide both directions easily.

In the diagram it shows the two different couplers. You need to mark the copper pipe with the fittings centered so that when you have the piece in with the couplers you'll know they are centered.

Name:  coupler.jpg
Views: 487
Size:  15.2 KB
 
  #3  
Old 01-22-17, 09:34 PM
D
Member
Thread Starter
Join Date: Jan 2017
Location: USA
Posts: 41
Received 0 Votes on 0 Posts
thanks pete! that makes perfect sense. i knew there was a simple solution. lol
 
  #4  
Old 01-23-17, 09:03 AM
Z
Member
Join Date: Jan 2008
Location: Southeastern Pennsylvania
Posts: 3,189
Received 22 Votes on 22 Posts
denn-

You can use one coupling called a repair sleeve like these, which is used for bigger gaps like yours:

600-306 - Sioux Chief 600-306 - 3/4" x 6" Sweat Full-Slip Copper Repair Coupling

and do it like this:

How to Repair a Leaking Copper Pipe | The Family Handyman

In your case if your gap is 4 you would cut the repair coupling to 5.
 
Reply
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: