DoItYourself.com Community Forums > Plumbing, Piping, Water Heating, Wells, Air & Water Filtration and Conditioning > Toilets, Sinks, Showers, Dishwashers, Tubs and Garbage Disposals

Faucet part source

Thread Tools

Search this Thread

05-03-17, 06:59 PM

beedoola

Member

Thread Starter

Join Date: Oct 2014

Posts: 211

Upvotes: 0

Received 5 Upvotes on 2 Posts

Faucet part source

Anyone know where I can source this part? The piece in the handle broke off and the handle is attached with a set screw.

Name: IMG_20170503_164927.jpg
Views: 260
Size: 48.7 KB

Name: IMG_20170503_164927.jpg
Views: 260
Size: 48.7 KB

Name: IMG_20170503_164934.jpg
Views: 210
Size: 50.0 KB

Name: IMG_20170503_165208.jpg
Views: 207
Size: 25.0 KB

Name: IMG_20170503_165224.jpg
Views: 153
Size: 33.2 KB

Name: IMG_20170503_165228.jpg
Views: 183
Size: 32.2 KB

Upvote

05-04-17, 07:47 AM

CarbideTipped

Member

Join Date: May 2015

Location: USA

Posts: 3,344

Upvotes: 2

Received 86 Upvotes on 68 Posts

Looks like it might be a Kohler 77548 or 77548-A. See if you can confirm it's a kohler faucet.

I think Kohler faucets have a lifetime warranty.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Toilets, Sinks, Showers, Dishwashers, Tubs and Garbage Disposals
Replacing outside hose bib

P

pwz2000 on May 02, 2017

I want to replace the hose bib outside because my water hose is not able to connect to it due to the size + it's in a tight spot as it's right on the brick (bad placement by builder). I bought an elbow extender but the connector on the bib is too large. I tried using a wrench to twist it off but perhaps I am doing it on the wrong part as it's not budging. You can see from the photos all I was doing was scraping the copper off. [ATTACH]80298[/ATTACH] [ATTACH]80299[/ATTACH] [ATTACH]80299[/ATTACH] [ATTACH]80300[/ATTACH]
Toilets, Sinks, Showers, Dishwashers, Tubs and Garbage Disposals
old cast iron tail pipe soldered into wall pipe.

C

Carol McD on May 05, 2017

I went to put on new bath sink trap, found the tailpipe is 1-1/4" iron, soldered into cast iron pipe in wall. The tailpipe end had become corroded and the short bottom rim broke off, leaving just the larger rim. What is a way to attach new trap without my having to heat up the soldered pipe to get it out & replace? Thanks to anyone with a suggestion that helps...

Do Not Sell My Personal Information

Cookie Settings

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2023 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Ask a Question