Water pump question

Reply

  #1  
Old 08-01-18, 12:48 PM
L
Member
Thread Starter
Join Date: Jul 2007
Location: Mexico
Posts: 364
Received 1 Vote on 1 Post
Water pump question

We live in Mexico.
We have a large covered pool-like tank in the ground near the garage which we use to give water to the sprinkler system as well as the smaller tank on the roof to feed the gravity fed water for the house.

We recently had the 1 hp pump - which can send water to a garden hose OR send water to the roof (from the tank) if there is no pressure at the street - serviced/rebuilt, Since then, after several attempts, the pump does not seem to 'hold' the prime. Water comes out the garden hose with force, but when I cut the power to the pump I hear a CLANG,CLANG,CLANG which then stops.

Am I 'hurting' the pump ? In order to prime this pump I have to remove a 1" screw and feed water into the hole.

Thanks
 
  #2  
Old 08-01-18, 04:11 PM
P
Group Moderator
Join Date: Mar 2003
Location: NC, USA
Posts: 24,683
Received 783 Votes on 720 Posts
The pump's check valve may not have been reinstalled correctly.

If something is loose or clanging around I would not run the pump unless absolutely necessary. If a needed part or bit comes loose it could get lost and difficult to replace, but if you can open it up and get it put back together properly it could be a easy fix.
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: