Pool table leveling
#1
Member
Thread Starter
Join Date: Feb 2019
Location: United States
Posts: 3
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Pool table leveling
Just recovered my pool table and re-did the seams on the three pieces of slate and all was good. Table was perfectly level.
When i died down the rails the seams where the slat meet are no longer level and i can feel a little bump where they meet.
What did I do wrong, what can i do to fix this?
When i died down the rails the seams where the slat meet are no longer level and i can feel a little bump where they meet.
What did I do wrong, what can i do to fix this?
#2
Welcome to the forums.
It sounds like the slates are rocking..... not sitting flat.
The slates should remain flat without the seam being applied.
Did you use wax ? Did the seam come apart ?
It sounds like the slates are rocking..... not sitting flat.
The slates should remain flat without the seam being applied.
Did you use wax ? Did the seam come apart ?
#3
Member
Thread Starter
Join Date: Feb 2019
Location: United States
Posts: 3
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Didn't come apart, but you can feel that one piece of slate is a little higher than the other. You can hear it when a ball crosses the seam. This was not the case before i tied down the rails.