Relative Humidity and Moisture Damage
Mold and condensation problems occur when the relative humidity is too high. Relative humidity is the amount of water vapor in the air compared to the amount the air can hold. Warm air can hold more moisture than cold air. So, if warm air and cold air contain the same amount of moisture, the warm air will have a lower relative humidity.
Two conditions cause the relative humidity to rise: when the temperature falls or when moisture is added to the air. Cold surfaces, such as windows or the inside of an exterior wall, create localized cold spots which reduce the amount of moisture the air can hold and raise its relative humidity. When water vapor is produced but is not being removed from the house, this, too, will raise the relative humidity.
Mechanical ventilation removes moisture from the house through ducts, so it doesn't have to travel through leaks in the walls, floors, and ceilings where it may hit colder surfaces and condense. Other ways to prevent moisture problems are to make these cold surfaces warmer with insulation; to block moist air from traveling through leaks by air sealing; and to add a vapor retarder to stop the diffusion of moisture through building materials.
Most molds grow at relative humidities of 70% or higher. Mold and mildew are virtually always present. They are not picky eaters and can find a feast in any home. Many building materials (from wood to plastic foam) provide nutrients for molds. When nutrients are combined with adequate moisture, molds can thrive.
You cannot eliminate mold from your home. But you can control the relative humidity to minimize its presence.
Where Moisture Condenses in Walls
- Condensation as moist air hits cooler surface: in a heated home, it condenses on the exterior sheathing; in a cooled home, it condenses on the back side of the drywall.
- A vapor retarder in this location would reduce the amount of moisture that diffuses into the wall cavity.